Artisan Technology Group Quest 210 Dokumentacja Pobierz pdf (Strona 22)

Argonaut Technologies Revision

06/24/98

8.5

Starting the Automated Solvent Wash Program

Before starting the program, Check that the Control Valves on side

of the Reactor Unit are turned

to CLOSED and CLOSED and that the MANIFOLD toggle valve is set to CLOSED. Rotate the

Reactor Unit to side A, set the Control Valves to SOLVENT and UTILITY

and the MANIFOLD

toggle valve to OPEN. Place the Glass Waste Tank below the Lower Manifold and open the Lower

Manifold Drain Valves. If there is liquid in the Reaction Vessels drain them before starting the

Automated Solvent Wash program.

Note: It is recommended to verify RV draining prior to running the automated solvent wash

program by manually filling the RVs with solvent followed by draining

Warning: Insure proper solvent deliver times before operating the Automated Solvent Wash

Option. Inappropriate solvent delivery times can cause over filling of the RVs creating cross

contamination between RVs, upper manifold clogs and solvent overflow into the ASWM.

Warning: Automated solvent washes generate a large amount of solvent waste. It is

recommended to connect a large secondary waste container to the Glass Waste Tank. Connect

a section of chemically resistant tubing to the valve on the Glass Waste Tank. The other end of

the tube should be connected to an appropriate secondary waste container.

8.5.1

Automated Solvent Wash Start Up Procedure

Press the MODE key until the Agitation menu is displayed. Enter the Agitation Parameters to be

used during the Automated Solvent Wash program. For an explanation of agitation settings refer

to the Quest Users Manual. Once the program is started the only adjustment available for the

agitation parameters is the Agitation Needle Valve.

Press the MODE key three times to display the AUTO SOLVENT WASH menu. A flashing

cursor is aligned to the right of Pgm: (program). Use the PARAMETER SETTING keys

to increment or decrement the program number until Pgm

is displayed.

Press the AGITATION ON soft key to start the Automated Solvent Wash program. The program

will begin at line

To start the Automated Solvent Wash program on a line other than line one, use the right or left arrow

keys to align the cursor over the desired line number. Pressing the AGITATION ON key displays the

menu shown in Figure

Current Line

Top of

Pgm

Don't Start

Figure

"To Start At" Menu

A. To start at the Current Line press the MODE key.

To start at the top of the program press the

(+)

PARAMETER key.

C. Pressing the left arrow key will not start the program, and will return to the previous

location on the AUTO SOLVENT WASH menu.

Q~JEST

ORGANIC'

SYNTHESIZER

IJTOMATED SOLVENT

WASH

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 32 33

Komentarze do niniejszej Instrukcji

Brak uwag

Artisan Technology Group Quest 210 Dokumentacja Strona 22

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Syntezator Artisan Technology Group Quest 210